6 Inch Ql 60 Dth Hammer Replace Atlas Copco Dth Hammers
Slant Face Bit From 4.75” To 12” (120.5 Mm – 305 Mm).
Bent Sub And Sonde Housing Available.
Accepts All Sondes, 15” & 19” (381-482.6 Mm)
Greater Air Flow Through Housing For Optimal Hammer Performance.
Excellent Steering In All Types Of Rock And Clay.
Easily Adaptable To All Hdd Drill Rigs.
Smaller Compressor Requirements (Job Dependent).
Reduced Operating Cost, No Drilling Fluid Recycling Needed.
Typically Only One Gpm Of Drilling Fluid For Operation.
Tested And Proven To Operate In Sands And Cobbles With Proper Drilling Fluid.
The Most Complete Lines Of Down The Hole Drills And Downhole Bits Ranging From 3.5” – 36” (89mm – 914mm) Which Are Designed For Peak Performance In All Rock Drilling Applications Including But Not Limited To; Foundation & Geotechnical Drilling, Blasthole Drilling In Quarries & Mines, Waterwell & Geothermal Boreholes, Oil & Gas Underbalanced Drilling, Horizontal Directional Drilling, And Utility Transmission & Distribution Rock Sockets.
Using the optimal air distribution size and cavity design and air tightness, the system consumes less than 10% of the fuel
The hammer frequency is faster than normal hammer .Drilling speed is faster than 15%.
the advanced heat treatment process, the surface of the hammer is strengthened, the wear resistance is improved 15%.
Specifications: Water Well Drilling
Product photos :